GTE wheel well molding fasteners?

The GT-E was only available for a few brief months in 1968. Total production would not have kept the assembly line busy for more than a half day. If you know anything about a GT-E, it is important, and this is the place to share it. The GT-E registry is maintained by Jim Pinkerton.
Post Reply
User avatar
akfordman
Registered Member
Posts: 73
Joined: 04 Sep 2013, 12:38

GTE wheel well molding fasteners?

#1

Post by akfordman » 08 Sep 2017, 17:30

Too many hands involved in the disassembly has resulted in not having any idea how to fasten the side mouldings around the wheel opening with those 5 holes in the molding on each wheel opening to the holes in the body around the wheel wells. I would assume a stainless steel screw through the hole in the aluminum molding. But, into what? There are just the holes in the body. Some sort of barrel insert? Is there room for a backing nut (not near car at the moment to look) inside the fender well wheel openings?

Sorry for the rookie question.

User avatar
akfordman
Registered Member
Posts: 73
Joined: 04 Sep 2013, 12:38

Re: GTE wheel well molding fasteners?

#2

Post by akfordman » 09 Sep 2017, 14:18

At the car and boy was that a dumb question. A big nevermind on this one. :oops:

Post Reply