Search found 358 matches

by preaction
28 Dec 2019, 20:34
Forum: Classic Cougar Speed Shop
Topic: Piston Pandemonium
Replies: 3
Views: 184

Re: Piston Pandemonium

Very good explanation easy to understand thanks for posting.
by preaction
28 Dec 2019, 10:42
Forum: Classic Cougar Community Discussion
Topic: CCOA magizine
Replies: 7
Views: 244

Re: CCOA magizine

Phillip, I missed it in that issue thanks for posting the ad and details.
by preaction
28 Dec 2019, 10:38
Forum: Classic Cougar Community Discussion
Topic: C70F-9510-B OEM Holley Squirters
Replies: 4
Views: 166

Re: C70F-9510-B OEM Holley Squirters

Squirter would be a 28.
by preaction
28 Dec 2019, 10:36
Forum: Classic Cougar Maintenance Restoration and Repair
Topic: Carburetor jet sizes...
Replies: 62
Views: 1304

Re: Carburetor jet sizes...

Rob, Im working on a new to me 428cj that is a all origional motor the initial is set at 6* and the idle adjustment screws do affect the idle so they are in range car starts right up and runs strong but runs on when turned off.
by preaction
27 Dec 2019, 15:12
Forum: Classic Cougar Community Discussion
Topic: CCOA magizine
Replies: 7
Views: 244

Re: CCOA magizine

Thanks Phillip, I was looking for the announcement for the Cougar national event next summer.
by preaction
27 Dec 2019, 15:10
Forum: Classic Cougar Maintenance Restoration and Repair
Topic: Carburetor jet sizes...
Replies: 62
Views: 1304

Re: Carburetor jet sizes...

Rob thanks for sharing your years of experience as this type of tuning takes many years of trial and error to master. Would using a initial timing on the higher side say 12 to 16* help slow down or eliminate running on after ignition shut off ? Also is the transition slot in at 50/50 when the slot i...
by preaction
27 Dec 2019, 11:25
Forum: Classic Cougar Community Discussion
Topic: CCOA magizine
Replies: 7
Views: 244

CCOA magizine

Has the last issue for 2019 gone out yet ?
by preaction
26 Dec 2019, 14:24
Forum: Classic Cougar Maintenance Restoration and Repair
Topic: Carburetor jet sizes...
Replies: 62
Views: 1304

Re: Carburetor jet sizes...

Where I was getting to was where the ford engineers were setting up vacuum advances to start using the spacers and spring in the vacuum advance adjusting feature. With a vacuum tree and its three points, distributer, portrd vacuum, and manifold vacuum where and when do these vacuums apply ?
by preaction
25 Dec 2019, 15:31
Forum: Classic Cougar Maintenance Restoration and Repair
Topic: Carburetor jet sizes...
Replies: 62
Views: 1304

Re: Carburetor jet sizes...

Lets say I have 12* initial timing with a all factory engine that has 10.5 to 1 compression its a 68 big block with an automatic so single advance distributor at what rpm would be be ideal for the ported vacuum to start to pull on the breaker plate I understand about all in by 3000 but when is the b...