And so it begins...

Make your Cougar run faster, handle better, and jump higher... okay maybe not jump higher. If you feel the need for speed, this is the place.
User avatar
JETEXAS
Registered Member
Posts: 385
Joined: 06 Aug 2017, 07:26
Location: Houston
Contact:

Re: And so it begins...

#31

Post by JETEXAS » 11 Jul 2018, 09:37

Can't wait to hear how it runs.
Image

DaveK
Registered Member
Posts: 165
Joined: 15 Jul 2013, 15:53
Location: Northern Virginia

Re: And so it begins...

#32

Post by DaveK » 16 Jul 2018, 17:37

Minor update - I got the temporary exhaust hooked up to the long tube headers, finished wiring everything and got the software uploaded to the Sniper unit.

I performed the initial setup and confirmed that I have a tach signal out of the MSD 6AL box to the Sniper.

Hopefully I'll get some gas in it and get it started this weekend.

DaveK
Registered Member
Posts: 165
Joined: 15 Jul 2013, 15:53
Location: Northern Virginia

Re: And so it begins...

#33

Post by DaveK » 30 Jul 2018, 05:22

I poured about 3 gallons of gas in the tank and hit the switch to prime the system. After checking for and fixing a minor fuel leak, I hit the starter and it came to life.

I need to adjust the Throttle Position Sensor and set the idle. Once I get those two things figured out, I'll put up a video.

User avatar
JETEXAS
Registered Member
Posts: 385
Joined: 06 Aug 2017, 07:26
Location: Houston
Contact:

Re: And so it begins...

#34

Post by JETEXAS » 07 Aug 2018, 10:45

What kind of throttle cable and shift cable setup did you use?
Image

DaveK
Registered Member
Posts: 165
Joined: 15 Jul 2013, 15:53
Location: Northern Virginia

Re: And so it begins...

#35

Post by DaveK » 07 Aug 2018, 11:10

I used the stock throttle and kickdown linkages.

Post Reply