Classic Cougar Community

Has anyone had any experience with the power window regulator drive gear on WCCC

Looks like a better idea than the cheap plastic gears they sell...

Have a 71 cougar XR7 4 speed my Power steering ,steering box input shaft Is leaking. Bought a rebuild kit and replaced all the seals and O rings,...

Looking for an XR-7G, any condition will do but prefer a driver ready for restoration.

Best regards,
MaseratiTMC

I like like how clean the 67/68 rear quarter panels look without the Cougar/Running Cat emblem but the reproductions are quite lovely so looking for...

Does anyone have a picture and specification for the mass damper on the C4, including the weight and construction.

I need to built one for my 68....

Been looking for a Weber & Cooper license plate frame (Ontario California) for a while now. Thought I would post here and see if anyone knows of one...

RUG C2, close ratio 390 trans, I got it with a bunch of parts and have never ran it, moves freely, 2nd gear saw teeth are worn, $550. o.b.o.

The bezels are from '68 Lincoln Mark III, Wiring harness is also from Mk III but can be used in an XR7- G with a connector change.

See here:

Mine - here is a link.

Mine - here is a link.

Working used distributor for 1970 Mercury Cougar and Ford Mustang with 428 Cobra Jet and 4 speed manual transmission. Also fits 428SCJ engines with 4...

Don at WCCC suggested I ask in this chat room if anyone knows if it would be a problem swapping out the engine frame mounts on a 71 XR7 convertible...

Will buy cores or good used $30-65 each. Will also buy hood lips and LH trim but I have 8 incomplete sets that are impossible to sell until I get a...

Hey all,

I'm hoping to keep the factory appearance of my car intact, but it's almost impossible to find good hubcaps. I might end up going with...

I'm located in New Mexico 40 miles south of Albuquerque. I don't have a price in mind so make a decent offer. Its in good shape, was a California...

I think I'm going to need a new/different oil pan for my 289. There's been quite a bit written out there about the repro Scott Drake (and others) pan...

’95 SVO 302 “XXX” Engine and Carburetion, For Sale (apart for inspection) Located in Snohomish, WA

(1)
Engine Features
XXX Special Vehicle...

Hello All, For Sale are various 1970 Hoods & Headlight Grille parts that I have had stored for many years.
(2) Hoods are available, and both were...

Hello All, For Sale is a 1970 Deck Lid that was acquired from a Western New Mexico parts car. Grade 'B', rust-free panel.
Deck Lid has been...

Hello All, For Sale is a 1969 Door (shell) that was acquired from a South Western Arizona parts car. Grade 'A', rust-free, wreck-free panel.
Door has...

Hello All, For Sale is a pair of 1970 Doors (shells) that were acquired from a Western Texas parts car. Grade 'A', rust-free, wreck-free panels....

Hello All, For Sale is a pair of 1970 Fenders that were acquired from a Western Texas parts car. Grade 'A', rust-free, wreck-free panels.
A few minor...

Hello All, For Sale is a NOS 69-70 Front Valance Panel: C9WY-17620-A in FoMoCo Black Service primer. Perfect condition; no dents or dings, with...

I need the seat tracks for two bucket seats and well as one rear bucket seat spacer.

Those of you that installed a aftermarket trans cooler on a 69/70 cougar with air conditioning , where did you mount it? If you have pictures please...